4x4 Cars

4WD for Sale, 1985 FJ60 Toyota Land Cruiser

Here Toyota FJ60 for Sale in Queen Creek has a 1987 Chevy TBI 350 rebuilt engine ready to go for a new owner.

Year of construction	1985
Brand	Toyota
Model	FJ60
Type	Wagon 4x4
Fuel	Gas
Color	White
Miles
License	Yes
Price	USD 13,500
Name	Owner
Phone	SOLD
City	Queen, Arizona

The specs are as follows:
Year = 1985
Motor = 1987 Chevy TBI 350 rebuilt
Trans = 1990 700r4 rebuilt ( Lokar shifter)
X-fer = 1985 split-case
Gears = 4.88 (installed by PO)
Traction control = Lock-Right lockers front and rear
Wheels/tire = (5x)255 85r16 Maxxis Bighorns on Grey steel Tacoma wheels. This combo has less than 1k miles on it.
Montero dash handle and gauge pod (pod houses tach)
Hella 24" Map Light at passenger A-pillar
ARB Safari Snorkel
Electric stereo antenna
Cut and folded rear quarters. This gives about 6" of additional clearance. The cut and fold job looks like a factory job but was not.
Parts for York OBA are uninstalled but included in sale
Cavernous custom center console.
Rear 1/4 panel storage boxes on both sides. Passenger side box include 10" subwoofer enclosure.
Custom exhaust with catalytic converter and O2 sensor installed.

The tent and Yakima rack are not included in the sale as they have been relocated.

Items that need attention are as follows:
AC compressor is in place but is not hooked up. Condensor is included and so are a set of used Toyota hoses and GM hoses. These ends can be used to make a set of custom hoses. A new dryer is needed.

The dual batteries shown have been replaced by a single battery. I never had a chance to set the dual system up properly and both batteries went bad while sitting. I am including the Ford alternator that was intended to run the second battery and the onboard welder I planned to build. I can supply links to the build thread I intended to follow on-line. The EGR valve needs the flow washer to be fine tuned so that the EGR circuit can be hooked up and the emissions equipment would then be 100% complete. Currently the EGR valve is not hooked into the ECU which causes a CEL. The truck runs flawlessly without this but it's something that needs buttoned up. The twin stick setup (HI-LO) and (2wd-4wd) linkage needs tweaking as it's not shifting perfectly every time. The Tcase shifts in and out of gears smoothly from below but the linkage is binding a bit. This is a custom setup as there was none available for this application at the time of the build.

The lockup wire for the transmission needs to be hooked up to a 12v source. The DVD player head unit is a cheap unit from Walmart that started giving me problems after a couple years of usage. It should be replaced along with the amplifier for the subwoofer. The Montero Gauge pod on top of the dash needs to be remounted or removed as it wiggles around a bit.